![](images/Newspaper.gif)
Shear Bond Strength of Veneering Composite Versus Different Polyetheretherketone Materials after Various Surface Treatments: An In-vitro Study
ZC42-ZC45
Correspondence
Dr. N Vidhyasankari,
Professor, Department of Prosthodontics, KSR Institute of Dental Science and Research, Tiruchengode-637215, Tamil Nadu, India.
E-mail: vidhya_3010@yahoo.com
Introduction: Polyetheretherketone, also known as PEEK, is a semicrystalline thermoplastic material with many advantages. Since its grey material, it has to veneering with composite resin to enhance its aesthetic appeal. Bonding PEEK and composite veneers poses challenges due to its inert surface.
Aim: To assess and compare the Shear Bond Strength (SBS) between various polyetheretherketone materials and veneering composites following various surface treatments.
Materials and Methods: The in-vitro study was conducted at KSR Dental College and Hospital in Tiruchengode, Tamil Nadu, India, over a period of three months from December 2022 to February 2023. A total of 108 PEEK discs were prepared for the study, divided into three groups: unfilled PEEK, 30% carbon reinforced PEEK, and 10% carbon+10% graphite+10% Polytetrafluoroethylene (PTFE) reinforced PEEK. The specimens underwent different surface treatments, including no treatment, sandblasting with 110 um alumina particles, and acid etching with 98% sulphuric acid. Additionally, 108 composite discs were prepared and bonded to the PEEK specimens using adhesive and resin cement. The bonded specimens were immersed in distilled water for 24 hours, and the Shear Bond Strength (SBS) was determined using a universal testing machine. Statistical analysis was performed using one-way ANOVA, and mean values were compared using posthoc tests.
Results: The results indicated significant variation in SBS among the three groups without treatment (p=0.011) and after sandblasting with 110 um alumina (p=<0.001). The 30% carbon reinforced PEEK exhibited the highest SBS regardless of the surface treatments.
Conclusion: Among the tested materials, 30% carbon reinforced PEEK demonstrated the highest SBS, regardless of the surface treatments. Acid etching yielded the highest SBS among the various surface treatments, irrespective of the type of PEEK material used.